Connector Wiring
Wires spliced into existing directional
harness.
At right is 2 pin male Molex connector (Available at most auto parts stores or http://www.vencowings.com/
)
+12V directional signal = Orange wire to LED red
wire. Ground = Green wire to LED black
wire.
See pictures below for LED mounting to wind wings.
LED = Amber Snake Eye Step Light #610-A (Available at most truck accessory
shops)
Molex 2 pin female connector (Available at most auto parts stores or http://www.vencowings.com/
) mates with male shown above.
Baker Built Wind Wings https://www.bakerbuilt.com/bbawindex.html
Finished view ( Front & Rear
)
Brakes = OFF Brakes = ON ( Note closing wings slightly makes LED more visable from rear. )
